2017 Walco Equipment SC-50

Mount to 35 to 100 hp tractor - 34 cutting wheel - 12 grinding depth

Grind through even the toughest stumps with ease with Shavers powerful line-up of PTO-powered, tractor mounted Stump Busters.

TWO TRACTOR POWERED UNITS: The powerful, industrial grade SC-50 and the compact SC-25, with lower tractor horse power requirements, so you can match you machine to your needs.

Features may include:

• utilizes an oversized shaft and heavy duty roller bearing in an oil bath.

• located under the sheied protects shear bolts and shaft from abnormally severe shock loads.

• made of steel plate, for long life.

• are hydraulically controlled from the safety of the tractor seat.

• conveniently supports the cutter when the unit is not in use, eliminating the strain in hinges

• Debris shoots away from tractor, into heavy, reinforced rubber shield. Easy clean-up.

• Cat. I and II 3-point arch support gives added stability

Shavers hydraulically powered Stump Buster is the choice for large contractors, landscapers and maintenance departments. These units feature Power, Durability and Simplicity

Mounted on a skid steer loader, they are easy to manoeuvre in compact areas that are impossible to reach with other types of machines.

• Eliminate stumps that are up to 45 in diameter, near buildings, sidewalks or hillsides, without repositioning the unit. Skid Steer mount allows improved visibility. Clean up a whole grove with stumps up to 2 high.

• Hydraulic motor powers the thick steel cutting wheel, easily turning hardwood into mulch. With the large cutting wheel and high hub torque, cut a full 55? swath below ground in less than 2 minutes

• Carbon steel teeth aggressively chew through stumps with little wear. Single direction cutting puts less stress on cylinder, bearings and gearbox. Heavy-duty bearings ride in an oil bath, virtually eliminating friction wear.

• Quick-tach system. Single toggle switch on loader allows the operator to move easily from stump to stump, without leaving the loader seat. 2-1/2 swing cylinder and hydraulic hoses are standard size for easy repair or replacement. Teeth are easy to access and replace using a standard wrench size